03 / Tools

A little less guesswork.

Small tools for the studio. Start with the numbers, see how they relate, and keep the assumptions in view.

Wire → coil → power.

Estimate geometry and electrical behaviour for one active resistance-wire element.

One uniform active element
RMS voltage, not automatically line voltage
Straight wire, excluding leads
Finished internal diameter, not outer diameter
Axial length along the installed coil path
Kanthal D: 1.35 · A-1: 1.45
1 = cold estimate. Enter alloy factor for hot values.

Your estimate

—Active wire length
—Resistance at 20°C
—Resistance at entered factor
—Power at entered factor
—Current at entered factor
—Active wire surface loading
—Pitch, centre to centre
—Number of turns

Engineering estimate, not a validated kiln repair specification. Check element temperature, supports, surface loading and the electrical design independently.

Coil equations, assumptions & sources

One continuous, uniform active element at the voltage entered. No series/parallel bank conversion, lead resistance, contact losses, thermal expansion, springback or changing coil diameter during stretching is included. Stretched length is the ideal axial advance along the coil path; end effects are ignored. The resistance factor must match the alloy and element temperature, not simply the kiln air temperature.

A = πd²/4 · r = ρ/A · R20 = rL · Rt = CtR20 · I = V/Rt · P = V²/Rt

For target power: L = V²/(P × Ct × r). With wire length Lmm, stretched length S and mean diameter Dm = Di + d: N = √(Lmm² − S²)/(πDm); pitch p = S/N; clear gap p − d. Surface area in cm² is πdLmm/100.

The example follows dimensions in the kiln project's main README. Its published pitch expression uses outer minus inner diameter; this planner uses mean centreline diameter. With 21.5 m wire, 1.6 mm wire diameter, 8 mm inside diameter and 3648 mm stretched length, that gives about 5.2 mm pitch. The esphome branch still needs comparison.

Resistivity references: Kanthal D datasheet and Kanthal A-1 datasheet. No universal acceptable surface-load range is assumed.

Shrinkage equation

Wet size = finished size / (1 − shrinkage / 100). This is a linear-size calculation, not a volume calculation.